Engineering Calculators / Wire Gauge

Wire Gauge Calculator

Enter the load and cable run to get a suggested AWG size. The recommendation is based on the voltage-drop limit for copper conductors; the NEC ampacity check is shown separately as a reference.

Sizing supports copper conductors only (the ampacity reference is the NEC copper table). To check an aluminum run, use the Voltage Drop Calculator.

Result

Enter your values and press Calculate.

How it works

The recommendation works in two layers. First, voltage-drop sizing: the calculator finds the smallest listed AWG copper conductor whose cross-section keeps the loop voltage drop within your limit. Sizes from 4/0 AWG down to 28 AWG are all candidates — 16 AWG and finer are common in custom harnesses even though they have no NEC building-wire ampacity rating.

Second, ampacity review: the recommended size is checked against NEC Table 310.16 (copper, 75 °C column). This is a building-wire reference, not a harness rating — it is shown as context and never used to exclude a size. When the pick has no NEC entry or its listed rating is below the load, the result is flagged as “ampacity not verified”, and where one exists a NEC-listed alternative is shown for building-wire use.

Voltage drop is computed as VD = k × I × L × ρ / A, where k = 2 for DC and single-phase AC (out-and-back loop), k = √3 for three-phase AC, ρ = 0.01724 Ω·mm²/m (copper at 20 °C), L is the one-way length in meters, and A is the conductor cross-section in mm².

Three-phase results assume a balanced load and use the line-to-line voltage; power factor and line reactance are ignored (resistive estimate). The resistivity is the 20 °C reference — no temperature correction is applied in this model, so drops at elevated operating temperatures will be somewhat higher.

A one-way length of 0 m is a mathematical edge case (zero resistive drop); real harnesses always include termination and contact resistance not covered here.

Have a Cable Assembly Project in Mind?

Send us your drawings, component references, or project requirements. We can review the available information and help identify the next steps for quotation.